Jump to content

  • Log in with Facebook Log in with Twitter Log in with Windows Live Log In with Google      Sign In   
  • Create Account

Submit your paper to J Biol Methods today!
- - - - -

How does fibronectin "crash out" of solution?

  • Please log in to reply
1 reply to this topic

#1 science noob

science noob


  • Active Members
  • PipPipPipPipPipPipPipPipPipPip
  • 284 posts

Posted 15 November 2012 - 11:20 PM

Anyone have any ideas about the mechanics? Based on Sigma's spec sheet: http://www.sigmaaldr...mp/f0556dat.pdf

And how do you thaw out fibronectin stocks (stored at -20 oC)? Millipore suggests slow thaw @37oC, Sigma suggests slow thaw @2-4 oC. Thoughts?

#2 Denny


    Denny Is As Denny Does

  • Active Members
  • PipPipPipPipPip
  • 78 posts

Posted 18 November 2012 - 06:59 AM

I found this manual BD sciences helpful, I do not know the mechanics of how it crashes out, but have had it happen in the past. Since using the methods I describe below I haven't had any problems...hope this helps

I have sucessfully used fibronectin for BAEC cells and resuspend in sterile ultra-pure water, aliquot according to predicted usage, into 1.5 ml tubes and place those tubes into 50 ml conical tubes, cap tightly then store at -20C. I thaw aliquots at 4C, then equillibrate to room temp for a few minutes. Gently invert the tube to mix, never vortex or shake vigorously.
I store the thawed aliquot at 4C if I will use it in the next week, otherwise re-freeze. Avoid repeated freeze/thaw by aliquoting small volumes, you can always thaw more tubes if you need them.

I dilute the fibronectin in PBS to desired concentration and coat with minimal amount, just enough to cover the surface uniformily with a thin layer of solution, incubate at 37C for 1 hour minimum, aspirate the excess just prior to use, wash with PBS, and add cells suspended in medium.

Also, if I know that I need more coated dishes in the next week or two, I coat additional flasks/plates, incubate and wash as above, store in a sterile bag (save sleeves from sterile plates that you've only opened in the hood), seal tightly and place in 4C for up to 2 weeks. I like to leave a thin film of PBS on the culture dish so that they don't dry out in the fridge.

As you know, fibronectin is very expensive and it doesn't go very far. I have been able to reduce our usage dramatically by testing different coating concentrations. Give it a try unless it's already been pre-determined by other lab peoples. The only draw back to reduced coating concentration was slower cell growth, we decided that the cost benefits were well worth the extra day or two waiting for cells to reach desired confluency and plan accordingly.

Good Luck!Posted Image

Edited by Denny, 18 November 2012 - 07:06 AM.

Home - About - Terms of Service - Privacy - Contact Us

©1999-2013 Protocol Online, All rights reserved.