Ferum level estimation in saliva
Posted 09 October 2012 - 11:33 AM
(I am a bit confused, if it is a good place for this topic, if no, sory and thank for replacement )
I am a studen of Dental Faculty, during preparation for scientific project it turned out, that estimation of ferum level is saliva taken from several patients would be very interesting. Unfortunately i can not find any "available for university students" method of this procedure. Biochemical faculty promised to help us in reagents and laboratory work, but still we have no good method of evaluation. Can you suggest us good method for estimation of ferum level in saliva? Any information/previous studies/methods will be very helpful
Posted 09 October 2012 - 12:19 PM
Posted 09 October 2012 - 12:26 PM
To be more precise: we are willing to better understand or to find a cause of very rare "pigmented plaque" on children's teeth. We suspect, that it may be partly caused by increased amount of Iron in their saliva. That's why we need to know their level and compare it with control patients. That's why I'm asking about laboratory method (reagents, procedure) which we can suggest to our biochemical department
I hope now it's a bit more clear
Posted 09 October 2012 - 12:33 PM
You might be better off asking an analytical chemist how best to estimate iron content in a sample. I suspect that something like mass-spec flame atomic absorption spectroscopy will be the most accurate method.
Posted 09 October 2012 - 01:49 PM
Posted 09 October 2012 - 02:26 PM
- Ferrozine method, colorimetric and very commonly used allows discrimination between Fe(II) and Fe(III)
- Phenantroline method, also colorimetric
ICP and AAS are quite simpler as there is no problem redisolving the plaque, but for ferrozine you will probably have to disolve and neutralize to avoid problems with very extreme pH.
For both colorimetric methods you need the reactive and a spectrophotometer. For ferrozine you will also need ascorbic acid (I think it was ascorbic ) to reduce Fe(III) to Fe(II) and measure total Fe because ferrozine only binds to ferrous iron. I just did a couple of times but the method is easy to find online.
Posted 10 October 2012 - 05:56 AM
genius does what it must
i do what i get paid to do