Jump to content

  • Log in with Facebook Log in with Twitter Log in with Windows Live Log In with Google      Sign In   
  • Create Account

Submit your paper to J Biol Methods today!
Photo
- - - - -

Question about fixation and wash

fixation and wash

  • Please log in to reply
2 replies to this topic

#1 weining

weining

    member

  • Members
  • Pip
  • 1 posts
0
Neutral

Posted 02 October 2012 - 10:18 PM

I have a problem about flow sample preparation. We fix A549 cells with 0.5% PAF for 1 h in 4degC. At the end of fixation, cells were centrifuged with 1200 rpm, 5min, then washed with PBS and centrifuged with same speed. We found that cells were seriously lost (cannot precipitate) after second centrifugation. Can everyone tell us how to change our condition for avoiding sample lose? thanks.

#2 bob1

bob1

    Thelymitra pulchella

  • Global Moderators
  • PipPipPipPipPipPipPipPipPipPip
  • 5,826 posts
413
Excellent

Posted 03 October 2012 - 01:23 PM

Have you tried a higher speed spin?

Of note - if you are talking about centrifuges, rpm is not helpful as the force applied by the centrifuge is dependent on the radius of the rotor - you need to refer to RCF or gravity ("g") forces

#3 zodiac1505

zodiac1505

    Enthusiast

  • Moderators
  • PipPipPipPipPip
  • 92 posts
3
Neutral

Posted 18 October 2012 - 06:51 AM

Are you fixing the samples just prior to FACS acquisition? In that case, you can just remove the antibody mix with one spin and then resuspend the cells in the fixative and proceed straight to the acquisition stage. Avoiding the extra spin steps can prevent the loss of cells.

In case you are fixing the cells and have to really do all the spins, try going for 300G for 10 minutes. Once fixed, it is easy to lose cells and so a longer spin time might get them pelleted. I never go lower than 1500 rpm and 6-7 minutes even when I am working with cells that are not fixed.




Home - About - Terms of Service - Privacy - Contact Us

©1999-2013 Protocol Online, All rights reserved.