qPCR contamination problem
Posted 29 August 2012 - 02:14 PM
I wonder how this may happen? Please give me some suggestions, so that I can improve it.
Besides, I feel it really hard to totally avoid contamination with 96-well plates. I am thinking, as the air flow is from lab room into fume hood, will the air turbulence make it easier to contaminate as the wells are not covered during adding templates? Is there a method to avoid it?
Posted 29 August 2012 - 02:42 PM
Contamination is a very difficult thing to get rid of. It is quite likely that your contamination is from PCR product from other reactions that is floating around the lab in aerosolized form. You should throw out all your reagents and clean your pipettes out thorughly, use filter tip if you can, as these stop DNA from entering your pipettes.
If possible it is best to have a set of pipettes that are used only for setting up reactions (NOT for the DNA though - keep a separate one for this) and have a separate set for loading PCRs onto gels, that are used for this purpose only.
Posted 29 August 2012 - 05:34 PM
Posted 30 August 2012 - 01:46 PM
I think contamination from the air is quite rare. Most likely the problem is contamination in the reagents or water. I would be using barrier tips and make sure that my pipettors were clean.
Posted 30 August 2012 - 02:21 PM
Posted 31 August 2012 - 06:21 AM
If you use one of the common master mixes for qPCR, they contain dUTP. If you run the same assays over and over again and open the finished reactions, you may have contaminated the enviroment by previous product. UDG treatment before each reaction can prevent this.
However more often is contamination by the template itself where the UDG won't help. But you can probably try it to identify the source of contamination.
I never really get the point in wiping the outsides of a pipett, but that won't hurt I guess. The insides are however most important, some pipettes have autoclavable shafts/tip holders.
If you now get consistent contamination you may have already one of the solutions you use contaminated. So you have to clean and change everything possible (pipettes, box,...) and change all reagents that can be changed to be sure you start anew clean. If you not using PCR water from a kit, make sure it couldn't get contaminated before you use it (or by "sterilisation" itself).
Our country has a serious deficiency in lighthouses. I assume the main reason is that we have no sea.
I never trust anything that can't be doubted.
'Normal' is a dryer setting. - Elizabeth Moon