I am using this ELISA assay kit: http://www.ebioscien..._88/88-7324.pdf
They don't mention plate shaking in their procedure, but I know for most ELISAs you need plate shaking during the incubation periods.
Does it depend on the assay kit or should I just do it anyway?
Thanks!
0
2 replies to this topic
#2
Gerard
-
- Active Members
-
- 124 posts
Veteran
0
Neutral
Neutral
Posted 22 November 2009 - 03:58 AM
I would advise to start with no shaking because the assay will be tested as described in the PDF.
Most of the time shaking will be okay but the there is the possiblity you have to adjust times to get the right OD because shaking mostly will cause the OD to go up.
Most of the time shaking will be okay but the there is the possiblity you have to adjust times to get the right OD because shaking mostly will cause the OD to go up.
Ockham's razor
Pluralitas non est ponenda sine necessitate
-- "You must assume no plural without necessity".
Pluralitas non est ponenda sine necessitate
-- "You must assume no plural without necessity".
#3
Prep!
-
- Active Members
-
- 517 posts
Am I me???!!!
4
Neutral
Neutral
Posted 23 November 2009 - 01:21 AM
normally plate shaking is to increse the efficiency of binding to the antibody. R and D systems kits have two kinds of protocol with the same reagents... one with and one without shaking..
only difference would be double incubation times in the benchtop protocol than the shaker protocol
Best luck!!
only difference would be double incubation times in the benchtop protocol than the shaker protocol
Best luck!!
Support bacteria - They are the only culture some people have!!!
Cheers!!!
Cheers!!!
