Jump to content

  • Log in with Facebook Log in with Twitter Log in with Windows Live Log In with Google      Sign In   
  • Create Account

Submit your paper to J Biol Methods today!

(View All Videos) Toggle BioVideo

* * * * -

How to avoid contamination in PCR?

PCR contaminations are like ghosts... you know they are there but you dont know WHERE??

I have followed the following with good results...
  • Prepare your master mix in a separate room from your current location, somewhere PCR is not the main practice... Be sure to have a separate lab coat, gloves, tubes, pipette tips tobe used only in that clean room.
  • Use a separate aliquot of DEPC water stock for each round of PCR
  • Prepare your mix in a hood with laminar flow. Decontaminate it with bleach, alcohol, RNAse, DNase, etc... Be sure to UV-irradiate pipettes, pipette tips, tubes, racks, gloves, and also your aliquots of water and PCR buffer... before the procedure.
  • Use a different pipette tip when pipetting all your reagents, even the same master mix to each tube
  • Keep your tubes closed during the procedure, even your master mix tube. Be sure that your tubes are closed when discarding the pipette tip!!! Aerosols are dangerous!!! Open the tubes only when necessary.
  • More important... schedule your PCR when not handling plasmids!!!

Hope this help...
Good luck


Contamination will occur. It just takes one moment, one droplet.

So design your PCR kit with that in mind.

Aliquot all your PCR reagents. If contamination does occur, you can then discard all your current PCR reagents and take out new uncontaminated reagents.

This is how you should handle PCR contamination.
I have problem in PCR contaminations.
I doubt one of my primer that was contaminated
I had check water, pcrbuffer, dntp and Taq.

I don't want to design primer again.

So~can i use UV light to irradiate my reagents(include F and R )???

OR HAVE any other way to remove

thank you!!
I think you kan irradiate water, magnesium... but not F and R (as mutations interfere PCR!!!)

Importantly, I believe that post-pcr steps should be performed in a different room than pre-pcr steps.
thanks for the great info.im do new here...never done this work before,,i have a lot of problems handling PCR...at least now i know how to prevent contamination.
I did yeast colony PCR but no band at all,does anybody knows is crimson taq useful for yeast colony pcr?
colony pcr is usually very easy. even 25 cycles is enough. we don't boil to break the membrane. just directly add the colony into the pcr tube and run.
In my opinion the most important things are:
Don't do too many cycles (30 is enough for everything).
Don't open your PCR tubes in the same area as you (or other people for that matter) are doing the PCR preps. The amplicons get aerosolized and then they are everywhere.
Bananapaper, what is your "proof" of contamination? Non-specific bands, not bands at all, degraded sample? that will help people give you the best advice.

For non-specific bands, simple things like reducing template and primer concentrations can fix that. Or maybe the Taq has gone bad if you have no bands.

Sometimes if a primer solution/dilution seems to not work, that's the cheapest thing to replace--- $10-20 at most to just get a new tube of it synthesized.

Just curious!
my template DNA contains phenolic compounds..so am not getting amplification...What should I do to get amplification?
what is concentration of taq and MgCl2 will give the best amplification is there any fixed proportion of these two?
Home - About - Terms of Service - Privacy - Contact Us

©1999-2013 Protocol Online, All rights reserved.