Printable Version of Topic

Click here to view this topic in its original format

BioForum _ Cell Biology _ Selection of clones during transfection

Posted by: utsavi Aug 20 2004, 01:04 AM

Hi ,

How should one can decide the optimal concentration of geneticin to select a clone during stable transfection if it's not known at what concn. cells will die.

Posted by: Simonsays Aug 20 2004, 08:04 AM

In our lab, we use 0.8mg of G418 (geneticin) per ml of medium for selection, and we lower that to 0.4mg/ml to maintain the selective pressure after that. We work aon the HEK model. I don't know though if the same concentrations apply to other types of cell.

Hope I could help!

Simon

Posted by: kant0008 Aug 22 2004, 10:04 PM

Hi,
can you find out at what concentration cells will die? Construct a kill curve? It takes about 2weeks.
Otherwise 0.4-0.8mg/ml seems to be the range for most cell lines I use

Posted by: utsavi Aug 29 2004, 10:48 PM

Thanx for the response U have given to me.

But, these cells I'm working with are very sensitive, so can I start with 50ug/ml concn.But then my worry is Cells may loose the transfected DNA if selection pressure is too low.

Posted by: kant0008 Aug 29 2004, 11:08 PM

Hello again,
if you say your cells are sensitive then you can start with a low concentration of antibiotic. Theoretically for a sensitive cell line a small amount of it should still be enough to maintain a selective pressure. You can always run a control non-transfected well, to make sure you are not getting random mutants. If you have the option I'd still try a kill curve, it might actually save you time and cells in the long run.
Good luck!