This is a cached page for the URL ( To see the most recent version of this page, please click here.
Protocol Online is not affiliated with the authors of this page nor responsible for its content.
About Cache
Chapter 9: Tubules\Filaments

Exercise 9.9 - Isolation of Actin and Myosin Filaments



Procedure 7

  1. Obtain fresh chicken gizzards 8 and dissect the lateral muscles free from all attachments. Place the muscles on crushed ice and then grind them in a standard worm- drive meat grinder. Small samples can be pushed through a hand press, if desired.

  2. Weigh the tissue and add an equal volume of cold 0.05 M Sodium phosphate buffer, pH 7.0 with 0.001 M EDTA. Blend this mix in a standard blender at low speed and pour the slurry into a large beaker.

  3. Upon settling, the muscle fragments will settle on top of the underlying connective tissue. Separate the two by decanting, and concentrate by low speed centrifugation.

  4. Suspend aliquots of blended muscle in two volumes of relaxing solution and homogenize in a blender at high speed for 30 seconds.

  5. Centrifuge the homogenate at 500 xg to remove membraneous organelles and whole cells. The myofilaments are preferentially localized in the middle, clear solution of the centrifuge tube.

  6. Collect the middle layer and recentrifuge at 40,000 xg to pellet the myofilaments. Wash and gently resuspend. This will rid the preparation of soluble proteins.

  7. Prepare a small sample of the middle layer from Step 5 for EM observation, following the procedure outlined above for tubulin (Exercise 9.7).

Return to Table of Contents

Cell Biology Laboratory Manual
Dr. William H. Heidcamp, Biology Department, Gustavus Adolphus College,
St. Peter, MN 56082 --