This is a cached page for the URL (http://www.genosys.co.uk/custom_synthesis/tech_info/designing.html). To see the most recent version of this page, please click here.
Protocol Online is not affiliated with the authors of this page nor responsible for its content.
About Cache

Designing Your Peptide

While peptide synthesis can be straightforward, it is important to consider several factors before synthesis commences. The sequence, amino acid composition and length of a peptide will influence whether correct assembly and purification are feasible. These factors also determine the solubility of the final product. The following summary highlights some important points you should consider in the design of your peptide. If you would like Sigma-Genosys to help you in designing your peptide, our technical support department can assist you.

Length of Sequence

The purity of a crude peptide typically decreases as the length increases. The yield of peptide for sequences less than 15 residues is usually satisfactory, and such peptides can typically be made without difficulty. In addition, peptides of 10-15 residues in length are satisfactory for raising antisera to linear epitopes of intact proteins.

Hydrophobic Stretches

The overall amino acid composition of a peptide is an important design variable that is frequently overlooked. A peptide's solubility is strongly influenced by composition. Peptides with a high content of hydrophobic residues, such as Leu, Val, Ile, Met, Phe and Trp, will either have limited solubility in aqueous solution or be completely insoluble. Under these conditions, it will be difficult to use the peptide in experiments, and it may be difficult to purify the peptide if necessary. It is advisable to keep the hydrophobic amino acid content below 50% and to make sure that there is at least one charged residue for every five amino acids. At physiological pH Asp, Glu, Lys, and Arg all have charged side chains. A single conservative replacement, such as replacing Ala with Gly, or adding a set of polar residues to the N- or C-terminus, may also improve solubility.

Difficult Amino Acids

Peptides containing multiple Cys, Met, or Trp residues are also difficult to obtain in high purity partly because these residues are susceptible to oxidation and/or side reactions. If possible, one should choose sequences to minimize these residues. Alternatively, conservative replacements can be made for some residues. For instance, Norleucine can be used as a replacement for Met, and Ser is sometimes used as a less reactive replacement for Cys. If a number of sequential or overlapping peptides form a protein sequence are to be made, making a change in the starting point of each peptide may create a better balance between hydrophilic and hydrophobic residues. A change in the number of Cys, Met, and Trp residues contained in individual peptides may produce a similar effect. As an example, if the stop or start point for choosing peptides separates two Cys residues into two peptides, this may allow for better synthesis and purer final product.

Secondary Structure

Beta-sheet formation is a final consideration in peptide design. During synthesis, beta-sheet formation causes incomplete solvation of the growing peptide and results in a high degree of deletion sequences in the final product. This problem can be avoided by choosing sequences which do not contain multiple and adjacent residues comprised of Val, Ile, Tyr, Phe, Trp, Leu, Gln, and Thr. If sequences cannot be chosen to avoid stretches of these residues, it often helps to break the pattern by making conservative replacements, for example, inserting a Gly or Pro at every third residue, replacing Gln with Asn, or replacing Thr with Ser.